Above values from ASTM A Higher strengths can be produced by heavy cold work – this may be required for certain applications. ASTM A – 16 Standard Specification for Stainless Steel Wire and Wire Rods for Cold Heading and Cold Forging. This specification covers. See the chemical composition and physical properties of ASTM A Grade annealed Stainless Steel, find alternative materials, and connect with suppliers.

Author: Arashinris Fesho
Country: Togo
Language: English (Spanish)
Genre: Politics
Published (Last): 22 January 2014
Pages: 185
PDF File Size: 1.88 Mb
ePub File Size: 14.96 Mb
ISBN: 710-7-16021-627-1
Downloads: 51608
Price: Free* [*Free Regsitration Required]
Uploader: Fauzil

ASTM does not give any warranty express or implied or make any representation that the contents of this abstract are accurate, complete or up to date.

General Requirements for Delivery 4. B Product analysis tolerance over the maximum limit for carbon and nitrogen to be 0. Referenced Documents purchase separately The documents listed below are referenced within the subject standard but are not provided as part of the standard.

A number in parentheses indicates the year of last reapproval. Historical Version s – view previous versions of standard. For smaller sizes, similar mechanical properties apply to ferritic and martensitic grades; however the producer should be consulted regarding somewhat higher tensile properties applicable to austenitic grades.

An electroplated copper coating is often used. The following coatings may be specied: All austenitic grades in the annealed condition or annealed and lightly drafted condition shall be capable of passing the criteria set by this specification. The American Society for Testing and Materials takes no position respecting the validity of any patent rights asserted in connection with any item mentioned in this standard.


Link to Active This link will always route to the current Active version of the standard. This standard is subject to revision at any time by the responsible technical committee and must be reviewed every ve years and if not revised, either reapproved or withdrawn.

It is informational only and not an official part of the standard; the full text of the standard itself must be referred to for its use and application. Resistance to Intergranular Corrosion 8. Users of this standard are expressly advised that determination of the validity a4933 any such patent rights, and the risk of infringement of such rights, are entirely their own responsibility.

ASTM A493 for Stainless Steel Wire and Wire Rods for Cold Heading and Cold Forging

Soap is generally used. This standard has been approved for use by agencies of the Department of Defense. Last previous edition A — The producer should be consulted when material is required to tensile strength ranges xstm than those specied. Copyright ASTM Standard Specication for Stainless Steel Wire and Wire Rods for Cold Heading and Cold Forging1 This standard is issued under the xed designation A ; the number immediately following the designation indicates the year of original adoption or, in the case of revision, the year of last revision.


Current edition approved Jan. Packaging and Package Marking 9.

ASTM A493 Grade 384 annealed

The values given in parentheses are mathematical conversions to SI units that are provided for information only and are not considered standard. Your comments will receive careful consideration at a meeting of the responsible technical committee, which you may attend.

The material shall also conform to the requirements as to mechanical properties. ICS Number Code NOTE 1—A typical ordering description is as follows: A superscript epsilon e indicates an editorial axtm since the last revision or wstm. This specification covers cold-finished and hot-finished stainless steel wire and wire rods for cold heading or cold forging for applications, such as fasteners, where corrosion resistance is a factor.

ASTM A for Stainless Steel Wire and Wire Rods for Cold Heading and Cold Forging

Originally published as A — The SI equivalents are in parentheses and may be approximate. Such requirements ast include, but are not limited to the following: Your comments are invited either for revision of this standard or for additional standards and should be addressed to ASTM Headquarters. The following lubricants may be specied:

Back to top